Motor mock up
-
SilverXJ
- Global Moderator
- Posts: 5790
- Joined: February 14th, 2008, 7:14 am
- Stroker Displacement: 4.6L
- Vehicle Year: 2000
- Vehicle Make: Jeep
- Vehicle Model: Cherokee
- Location: Radford, Va
Re: Motor mock up
There is no "correct", as the are all correct. I think the most used is the gage length method.
2000 XJ. 4.6L stroker
00+ Viper Coil Swap | CPS Timing Increase Mod | Fabricated Airbox | Dash bezel, Arduino Multigauge & RD Conceal
Eat, breath, drink, sleep, Jeep, drink
00+ Viper Coil Swap | CPS Timing Increase Mod | Fabricated Airbox | Dash bezel, Arduino Multigauge & RD Conceal
Eat, breath, drink, sleep, Jeep, drink
-
Maddawg
- Donator
- Posts: 72
- Joined: March 1st, 2009, 9:20 pm
- Stroker Displacement: 4.6
- Vehicle Year: 2000
- Vehicle Make: jeep
- Vehicle Model: G.Cherokee
- Location: Massillon,Ohio
Re: Motor mock up
Ok, but isn't .017 an awefull large tolerence? What about the perload?
2000 Grand Cherokee 4.6
SRC 10.03 DRC 7.74
Deck height .010
Head shaved .010
Bore .030
Rugged Ridge Header
SRC 10.03 DRC 7.74
Deck height .010
Head shaved .010
Bore .030
Rugged Ridge Header