Got the head on and checking for pushrods...
Put the ol' adjustable pushrod in there with #1 at TDC...
Pushrod starts at 8.800, twisted it up until it just barely stops on the torqued rocker arm...counted 13.5 turns...
Since 1 turn=.050 that ends up being .675+8.800=9.475...
So...with .040 to .060 for preload should I order 9.515-9.935 pushrods?
Just checking with the experts that be...and those that have learned from thier mistakes...Thanks in advance!!
Check my measurements...Please...
-
cigarluvr
- Making Progress
- Posts: 79
- Joined: December 3rd, 2009, 1:17 pm
- Vehicle Year: 1993
- Vehicle Make: Jeep
- Vehicle Model: ZJ
-
SilverXJ
- Global Moderator
- Posts: 5790
- Joined: February 14th, 2008, 7:14 am
- Stroker Displacement: 4.6L
- Vehicle Year: 2000
- Vehicle Make: Jeep
- Vehicle Model: Cherokee
- Location: Radford, Va
Re: Check my measurements...Please...
Sounds about right, assuming the 9.935" was suppose to be 9.535". I would also check a few of the rockers as well, not just one.
2000 XJ. 4.6L stroker
00+ Viper Coil Swap | CPS Timing Increase Mod | Fabricated Airbox | Dash bezel, Arduino Multigauge & RD Conceal
Eat, breath, drink, sleep, Jeep, drink
00+ Viper Coil Swap | CPS Timing Increase Mod | Fabricated Airbox | Dash bezel, Arduino Multigauge & RD Conceal
Eat, breath, drink, sleep, Jeep, drink
-
cigarluvr
- Making Progress
- Posts: 79
- Joined: December 3rd, 2009, 1:17 pm
- Vehicle Year: 1993
- Vehicle Make: Jeep
- Vehicle Model: ZJ
Re: Check my measurements...Please...
As always thank you for the help...
And will do on the checking more than one...
And will do on the checking more than one...